Labocosmetica ÈNERGO | Water Spot & Limescale Remover
Labocosmetica ÈNERGO — Water Spot & Limescale Remover
Ènergo is the gel that dissolves the contamination polishing can't safely reach — water spots, limescale, acid-rain etching and bonded mineral deposits on both paint and glass. Minerals bond aggressively to a surface, and grinding them off with a machine means unnecessary abrasion; Ènergo breaks them down chemically first, so you correct less and preserve more clearcoat.
The gel formula is the practical bit: it clings to vertical glass and panels, dwells where you put it, and lets you treat a single water-spotted area without the product running off. It also doubles as a prep step before glass nano-coatings, leaving the surface degreased and purified for a proper bond.
KEY FEATURES & BENEFITS
- Chemical mineral removal. Lifts water spots, limescale, acid-rain residue and bonded minerals from paint and glass — no abrasion required.
- Less polishing. Breaks staining down before the machine comes out, cutting correction time and saving clearcoat.
- Controlled gel. Clings to vertical surfaces, dwells, and treats spots precisely with no waste.
- Coating prep. Purifies and degreases glass ahead of a nano-coating for better adhesion.
DIRECTIONS
Ensure the surface is clean and cool, and work out of direct sunlight. Dilute according to contamination level if required. Apply via spray bottle, applicator pad or soft brush and allow to dwell for approximately 2–3 minutes. For severe staining, apply pure in small sections and agitate gently if needed. Rinse thoroughly with water and wipe with a damp microfibre if necessary. On delicate, soft or single-stage paint, avoid pure product and proceed with caution to prevent marking.
DILUTION
- Pure (1:0) — severe mineral staining
- 1:5 — medium contamination
- 1:10 — light contamination
Always adjust dilution to the surface condition and sensitivity.
SDS (Safety Data Sheet)